Follow these next instructions: 1) Connect your ESP8266 to your computer with a USB cable: 2) Go to Tools to select your ESP board model. You also have to choose your ESP’s COM port. 3) Open the BasicOTA.ino example: File > Examples > Arduino OTA > BasicOTA.ino or copy the following sketch to your Arduino IDE. The BME280 can measure temperatures ranging from -40°C to 85°C. Over the temperature range of 0 to 65°C, the accuracy is ±1.0°C; outside of that range, the accuracy drops to ±1.5°C. Note that this temperature measurement is used internally to calibrate the pressure and humidity sensors. Because the sensor self-heats, the measured Wemos mini bmp180 sensor example. This bmp180 from Bosch is the best low-cost sensing solution for measuring barometric pressure and temperature. The sensor is soldered onto a PCB with a 3.3V regulator, I2C level shifter and pull-up resistors on the I2C pins. The BMP180 replaces the BMP085. Is this code work on WEMOS D1 Mini pro board? And when it open serial monitor taping the card it did not shown any sentence . system Closed May 5, 2021, 11:31pm Step 3: Setup 2. The desired Thingspeak field number must be entered to Start field (1-8). This field is important if multiple devices are sending datas to the same thingspeak channel. For example: 2 WiFi loggers are working simultaneously, each has 3 temperature sensors. {"payload":{"allShortcutsEnabled":false,"fileTree":{"examples/SH1106Demo":{"items":[{"name":"SH1106Demo.ino","path":"examples/SH1106Demo/SH1106Demo.ino","contentType Dears, Theoretically I have a Wemos_d1_mini32 board. And I want to use the following adc pins: adc2_7 and adc2_2 according with the following scheme that I find in internet: According wiht the image there are 16 adc pins available for this board… But is impossible to select in ESPhome. Without errors I only can select the following adc pins: A0, A3, A4, A5, A6, A7 with the following code zHlR6M.

wemos d1 mini i2c example